Micro Controller Based Energy Efficient Four Steps Charging of a Capacitor Using a Buck Converter with Consecutive Changes of its Duty Ratio

  IJETT-book-cover  International Journal of Engineering Trends and Technology (IJETT)          
  
© 2015 by IJETT Journal
Volume-27 Number-2
Year of Publication : 2015
Authors : Mohammad Sehon Pasha, G.C.Prabhakar
DOI :  10.14445/22315381/IJETT-V27P215

Citation 

Mohammad Sehon Pasha, G.C.Prabhakar"Micro Controller Based Energy Efficient Four Steps Charging of a Capacitor Using a Buck Converter with Consecutive Changes of its Duty Ratio", International Journal of Engineering Trends and Technology (IJETT), V27(2),89-93 September 2015. ISSN:2231-5381. www.ijettjournal.org. published by seventh sense research group

Abstract
Since the discovery of Electricity, we have sought effective methods to store that energy for use on demand. Energy efficiency is “using less energy to provide the same service”. A capacitor can store maximum energy with respect to input by using direct charging method. In this paper four steps charging of capacitor by consecutively changing the duty cycle of Buck converter. In four step charging, dissipation energy is reduced to one 4th when compared with the conventional direct charging. The reduced dissipated energy is verified by MATLAB simulations and by breadboard experiment with help of Micro controller, which an energy reduction of one fourth is confirmed from the measured power supply currents in four step charging.

 References

[1] L. J. Svensson and J. G. Koller, “Driving a capacitive load without dissipating fcv2 ,” in Proc. IEEE Symp. Low Power Electron., 1994,pp. 100–101.
[2] W. C. Athas, “Energy-recovery CMOS,” in Low Power Design Methodologies, J. M. Rabey and M. Pedram, Eds. Norwell, MA,USA: Kluwer, 1996, pp. 65–100.
[3] Y. Moon and D. K. Jeong, “An efficient charge recovery logic circuit,” IEEE J. Solid-State Circuits, vol. 31, no. 4, pp. 514– 522, Apr. 1996
[4] R. Lal, W. Athas, and L. Svensson, “ A low power adiabatic driver system for AMLCDs,” in Proc. IEEE Symp. VLSI Circuits, 2000, pp. 198–201.
[5] S. Kim and M. C. Papaefthymiou, “True single-phase adiabatic circuitry,” IEEE Trans.VLSI Syst., vol. 9, no. 1, pp. 52–63, Jan. 2001.
[6] A. Blotti and R. Saletti, “Ultralow-power adiabatic circuit semicustom design,” IEEE Trans. VLSI Syst., vol. 12, no. 11, pp. 1248–1253, Nov. 2004.

Keywords
Adiabatic circuit, conventional direct charging method, step wise charging, duty ratio.