Heat Analysis of PTFE Plates on Drilling Process by ANOVA Methodology
 |
International Journal of Engineering Trends and Technology (IJETT) |  |
| © 2016 by IJETT Journal | ||
| Volume-32 Number-6 |
||
| Year of Publication : 2016 | ||
| Authors : Desikan.S, Kalaiyarasan.V, Kannan. Ttm, Vijayakumar P |
||
| DOI : 10.14445/22315381/IJETT-V32P254 |
Citation
Desikan.S, Kalaiyarasan.V, Kannan. Ttm, Vijayakumar P"Heat Analysis of PTFE Plates on Drilling Process by ANOVA Methodology", International Journal of Engineering Trends and Technology (IJETT), V32(6),271-274 February 2016. ISSN:2231-5381. www.ijettjournal.org. published by seventh sense research group
Abstract
Nowadays Teflon (PTFE) plates and cylindrical rods play an important role in modern manufacturing trends,PTFE plates are suitable for corrosive environment like marine, automobile applications. In this experimental work ,the drilling process conducted on Teflon plates with various process parameters like spindle speed ,feed rate and drilling diameter and response parameter as heat generation is analyzed, in this experimental work L27 orthogonal array is used as DOE to optimize the parameters specifically signal to noise ratio curves and ANOVA techniques. It indicates spindle speed play an important role for achieving lower heat generation in PTFE Plates in drilling process.
References
[1] CatalinFetecau, Felicia Stan (2012) Study of cutting force and surfaceroughness in the turning ofpolytetrafluoroethylene composites with a polycrystalline diamond tool, Measurement, 1367–1379.
[2] Francisco Mata, V.N. Gaitonde, S.R. Karnik and J. Paulo Davim (2009)Influence of cutting conditions on machinability aspectsof PEEK, PEEK CF 30 and PEEK GF 30 composites using PCD tools, Journal of materialsprocessing technology, 1980– 1982, 1984–1987.
[3] Rama Rao. S, Padmanabhan (2012) Application of Taguchi methods andANOVA in optimization of process parameters for metal removal rate inelectrochemical machining of Al/5%SiC composites, International Journal ofEngineering Research and Applications (IJERA),192-197.
[4] G. Petropoulos, F. Mata, J. Paulo Davim (2008) Statistical study of surfaceroughness in turning of peek composites, Materials and Design, 218–223.
[5] Palanikumar, J. Paulo Davim(2007) Mathematical model to predict toolwear on the machining of glassfibre reinforced plastic composites, Materials and Design, 2008–2014.
[6] FarhadKolahan, Reza Golmezerji, MasoudAzadiMoghaddam (2012)Multi Objective Optimization of Turning Process using GreyRelationalAnalysis and Simulated Annealing Algorithm, Applied Mechanics and Materials, 2926-2932.
[7] FarukUnsacar (2006) SuleymanYald?z Design, development and testing of a turning dynamometer for cutting force measurement, Materials and Design, 839–846.
[8] Mustafa Gunay, IhsanKorkut, ErsanAslan, UlviSeker(2005) Experimental investigation of the effect of cutting tool rake angleon main cutting force,Journal of Materials Processing Technology.
Keywords
Drilling, PTFE, Process parameters, Heat generation, ANOVA