Effect of Cutting Speed and Feed Rate on Tool Wear Rate and Surface Roughness in Lathe Turning Process
 |
International Journal of Engineering Trends and Technology (IJETT) |  |
| © 2015 by IJETT Journal | ||
| Volume-22 Number-4 |
||
| Year of Publication : 2015 | ||
| Authors : Matthew Sunday Abolarin, Olugboji Oluwafemi Ayodeji, Jiya Jonathan Yisa, Popoola Solomon Olaoluwa, Ajani Clement Kehinde |
||
| DOI : 10.14445/22315381/IJETT-V22P236 |
Citation
Matthew Sunday Abolarin, Olugboji Oluwafemi Ayodeji, Jiya Jonathan Yisa, Popoola Solomon Olaoluwa, Ajani Clement Kehinde"Effect of Cutting Speed and Feed Rate on Tool Wear Rate and Surface Roughness in Lathe Turning Process", International Journal of Engineering Trends and Technology (IJETT), V22(4),171-173 April 2015. ISSN:2231-5381. www.ijettjournal.org. published by seventh sense research group
Abstract
Machining is a vital part of the production process in the manufacturing industries. Turing operation was carried out on the mild steel to produce shaft of various diameters. The conditions applied during the turning operation include varying the cutting speed and feed rate while keeping other cutting variables like depth of cut constant. The results affirms that an increase in the cutting speed causes a decrease in the tool life, increase in the feed rate also affects the surface finish obtained.
References
[1] Boyer H.E and Gall T.L. (1985), Metals handbook, Desk edition.
[2]Avallone E.A. and Baumeister T. (1997).Mark’s standardhandbook.
[3] Higgins R.A. (1973). Engineering Metallurgy part l. Applied physical.
[4] William D.C., Jr., (1997). Materials science and engineering. An introduction to engineering.
[5]John V.B. (1983). Introduction to engineering materials, second edition, London.
[6] Chapman W.A.J. (1972). Workshop technology part I, An introductory course, fifth edition.
[7] Pandey P.C. and Singh C.K. (1995), Production engineering and science, first edition.
[8]Chapman W.A.J. (1975). Workshop technology part 3, Third edition.
Keywords
Microstructures, feed rate, cutting speed, tool life, depth of cut.