Single Inductor Multiple Output Buck-Boost Converter

  IJETT-book-cover  International Journal of Engineering Trends and Technology (IJETT)          
  
© 2017 by IJETT Journal
Volume-50 Number-3
Year of Publication : 2017
Authors : Jais Joseph, Prof. Dinto Mathew, Prof. Sera Mathew
DOI :  10.14445/22315381/IJETT-V50P226

Citation 

Jais Joseph, Prof. Dinto Mathew, Prof. Sera Mathew "Single Inductor Multiple Output Buck-Boost Converter", International Journal of Engineering Trends and Technology (IJETT), V50(3),167-172 August 2017. ISSN:2231-5381. www.ijettjournal.org. published by seventh sense research group

Abstract
There are many devices which provide multiple power supplies of different voltages. Voltage level may be greater than the source voltage or less than the source voltage depending on the application. Multiple supplies through the single source can be achieved by connecting multiple DC-DC converters in parallel but that will result in the requirement of large number of inductors of different values but inductors are bulky and difficult to integrate. To overcome this disadvantage we can use a Single Inductor Dual Output (SIDO) DC-DC converter. This SIDO DC-DC converter operates with one output in both buck and boost mode and other output in boost mode only. SIDO DC-DC converter has two switches, two diodes and a single inductor to multiplex the both output circuits by suitable switching. This reduces the size of the device, reduces cost, improve efficiency. Here the SIDO buck- boost converter is modified to Single Inductor Multiple Output (SIMO). By this we get three outputs with buck, boost and buck-boost operation. The simulation of the converter is performed using MATLAB/Simulink. The prototype for SIDO buck-boost converter with switching frequency of 20 kHz and an input voltage of 10 V is designed and implemented using PIC16F877A.

Reference
[1] Ajith Singh, Amit Kumar, “Analysis of single-inductor dual-output converter in buck and boost mode with voltage mode control", IEEE 6th International Conference on Power Electronics , vol.3, no.4, April 2016.
[2] Jaya Deepti Dasika, Behrooz Bahrani, “Multivariable Control of Single-Inductor Dual-Output Buck Converters", IEEE Transactions in Power Electronics, vol.29, no.4, pp.2061-2070, April 2014.
[3] Weiwei Xu, Ye Li; Xiaohan Gong, Zhiliang Hong; Killat, D., “A Dual Mode Single-Inductor Dual-Output Switching Converter With Small Ripple", IEEE Transactions in Power Electronics, vol.25, no.3, pp.614-623, March 2010.
[4] Dongwon Kwon, Rincon-Mora, G.A, “Single-Inductor Multiple-Output Switching DC-DC Converters", IEEE Transactions in Circuits and Systems, vol.56, no.8, pp.614-618, August 2009.
[5] Mandal, K., Abusorrah, AlHindawi, Al-Turki, Y., Giaouris, Banerjee, S., “Dynamical analysis of single-inductor dual-output DC-DC converters", IEEE Inter-national Symposium in Circuits and Systems, pp.2755-2758, 19-23 May 2013.
[6] Zhonghan Shen, Xuegui Chang, Weiwei Wang, Xi Tan, Na Yan, Hao Min, “Predictive Digital Current Control of Single-Inductor Multiple- Output Converters in CCM With Low Cross Regulation", IEEE Transactions on Power Electronics, vol.27, no.4, pp.1917-1925, April 2012.
[7] Ming-Hsin Huang, Ke-Horng Chen, “Single-Inductor Multi-Output (SIMO) DC-DC Converters With High Light-Load Efficiency and Minimized Cross Regulation for Portable Devices", IEEE journals in solid state circuits , vol.44, no.4, pp.1099-1111, April 2009.
[8] Kun-Yu Lin, Chun-Shih Huang, Dan Chen, Liu, K.H, “Modeling and design of feedback loops for a voltage-mode single-inductor dual-output buck converter", IEEE Specialists Conference in Power Electronics, pp.3389-3395, 15-19 June 2008.
[9] Quan Li, Shu Wu, “Single-Inductor Dual-Output Switching Converter using Exclusive control Method", IEEE 4th International Conference on Power Electronics , vol.36, no.8, May 2013.

Keywords
Single Inductor DC-DC Converter , Cross Regulation, Buck-Boost operation, Multiple Output.