An Investigation into the Properties of Concrete Containing Polyethylene (Pure-water sachet waste)

  IJETT-book-cover  International Journal of Engineering Trends and Technology (IJETT)          
© 2019 by IJETT Journal
Volume-67 Issue-8
Year of Publication : 2019
Authors : Nwaigwe, D.N., Sulymon, N.A, Bello, T. , Amiara, C.A.
DOI :  10.14445/22315381/IJETT-V67I8P212


MLA Style: Nwaigwe, D.N., Sulymon, N.A, Bello, T. , Amiara, C.A."An Investigation into the Properties of Concrete Containing Polyethylene (Pure-water sachet waste)" International Journal of Engineering Trends and Technology 67.8 (2019): 73-77.

APA Style:Nwaigwe, D.N., Sulymon, N.A, Bello, T. , Amiara, C.A. An Investigation into the Properties of Concrete Containing Polyethylene (Pure-water sachet waste)  International Journal of Engineering Trends and Technology, 67(8), 73-77.

One of the major environmental pollution problem experienced in Nigeria results from wastes disposal. In the recent, one of these wastes like the polyethylene wastes such as pure water sachets (PWS) which is non-biodegradable is increasing as a results of increase in population. This study investigates the performance of shredded PWS waste in concrete by partially replacing fine aggregates in different percentage of 0, 0.1, 0.2, 0.3, 0.4, 0.5, 1.0, 1.5 & 2.0% as an alternative means of disposal. A mix ratio of 1:2:4 was used and a total of 108 cubes (150mm x 150mm x 150mm) were cast, cured and tested at 7, 14 and 28 days respectively to determine its water absorption capacity, compressive strength and density of such concrete. The research thus revealed that incorporating shredded PWS in concrete has no significant effect on the water absorption property of concrete as the rate for all the samples are within acceptable limit based on standard. Increase in dose of PWS in concrete reduces the density of the concrete. The study also shows that 0.2% of shredded PWS incorporated in concrete gave a high compressive strength comparable to the control. However, this study recommends that 0.2% of SPBW incorporated in concrete can be used in concrete production since it falls within the minimum requirement for ordinary concrete with an average compressive strength of 10.0N/mm2 as recommended by BS8110 1(1997).

[1] AbdulGaffar, S., (2009). The use of renewable construction materials in a building in Nigeria. An Unpublished Final Project Report, Department of Building, Ahmadu Bello University, Zaria-Nigeria, Pp: 1-20.
[2] British Standard European Norm, (2002). Testing hardened concrete; Compressive strength test. BS EN 12390-3, BSI, Linfordwood, Milton Keynes MK146LE, U.K.
[3] British Standard European Norm, (1997). Tests for geometrical properties of aggregates; Determination of Particle size distribution-Sieving method. BS EN 933-1, BSI, Linfordwood, Milton Keynes MK146LE, U.K.
[4] Bello, T., Quadri, H.A., Akanbi, D.O. and Adeyemi, O.A. (2014). Investigation into Strength Properties of Polymer-Sand Aggregate Concrete. Civil and Environmental Research pp. 54-57 6(11)
[5] BS 8110 1-1997: Structural Use of Concrete- Part1: Code of Practice for Design and Construction. British Standard Institution. London British Standard Institute. Testing hardened concrete, Part 6: tensile splitting strength of test specimens. BS EN 12390-6:2000
[6] Dahiru D. and Usman J. (2014). Polymer Waste Material as Partial Replacement of Fine Aggregate in Concrete Productio. Research Journal of Applied Sciences, Engineering and Technology 7(21) Pp 4404-4409
[7] Dunu W., Albert I., Adaji A. A. & Ibiyemi B. S. (2016). Investigation into the Suitability of used Water Sachet (Polyethylene) as a Binder in the Production of Building Blocks. Education and science journal of policy review and curriculum development 6(1), 51-61.
[8] Falade F. (1997). The use of Ground Broken Bottles as Partial Replacement of Cement in Concrete. In: proceedings of Fourth International Conferences on Structural Engineering Analysis and Modelling, Ghana. Pp. 473- 486.
[9] Gowri, S. and Rajkumar, N. (2005):“Behavior of Plastic Mixed Reinforced Concrete Columns Under Axial Compression”. Department of Civil Engineering, Erode Sengunthar Engineering College, Thudupathi, Erode.
[10] Ijalana F.B., Afolayan J. O. and Adeleke O. E. (2016). Effects of Polythene Fibres on Selected Properties of Sandcrete Blocks. Nigerian Journal of Technology ( NIJOTECH) 35(1) pp. 37 – 42
[11] IS 10262 – 1982: Recommended Guidelines for Concrete Mix Design.
[12] IS 456 – 2000: Plain and Reinforced Concrete Code of Practice.
[13] Izam, Y. D. & Ameh, O. S. (2011). The concept of construction sustainability and it’s implication on the training of builders in Nigerian Univerities. In Sourcing, Development and Utilization of Appropriate Building Material for Sustainable Environment. Forty-one Annual Conference of Nigerian Institute of Building, 1-3.
[14] Malhutra, V. M. (2004). Role of Supplementary Cementing Materials and Superplasticizers in Reducing Greenhouse Gas Emission. Proceedings of ICFRC International Conference on Fiber Composites, High- Performance Concrete and Smart Materials, chennai India, Jan, pp. 489- 499.
[15] Nwaubani, S. O. and Poutos, K. I. (2013). Influence of waste glass powder fineness on the properties of cement mortar. International Journal of Application Or Innovation in Engineering and Management, 2(2), 110-116. Retrived from http:/
[16] Oyekan, G. L. & Kamiyo O. M. (2011). A Study on the Engineering Properties of Sandcrete Blocks Produced with Rice Husk Ash Blended Cement. Journal of Engineering and Technology Research, 3(3), 88-98.
[17] Peter, E., Albert, O. & Anthony, U. (2017). Nigerian Wood Waste: A Potential Resource for Economic Development. Journal of Applied Science and Environmental Management. 21(2), 246-251.
[18] Pitroda, J. and Shah, D. S. (2014). An Experimental Study on Durability and Water Absorption Properties of Pervious Concrete. International Journal of Research in Engineering and Technology, 3(3), 439-444. Retrieved from

Polyethylene waste, PWS, Compressive Strength, Water Absorption Rate, Density.